Canon : PIXMA Manuals : MG2500 series : Loading Envelopes

You can load Envelope DL and Envelope Com 10.

The address is automatically rotated and printed according to the envelope's direction by specifying with the printer driver properly.

Important

Printing of envelopes from the operation panel is not supported.

Do not use the following envelopes. They could jam in the machine or cause the machine to malfunction.

- Envelopes with an embossed or treated surface

- Envelopes with a double flap

- Envelopes whose gummed flaps are already moistened and adhesive

Press down on all four corners and edges of the envelopes to flatten them.

If the envelopes are curled, hold the opposite corners and gently twist them in the opposite direction.

If the corner of the envelope flap is folded, flatten it.

Use a pen to press the leading edge in the inserting direction flat and sharpen the crease.

The figures above show a side view of the leading edge of the envelope.

Important

The envelopes may jam in the machine if they are not flat or the edges are not aligned. Make sure that no curl or puff exceeds 0.1 inches (3 mm).

(1) Open the paper support.

(2) Pull out the paper output tray and the output tray extension.

(3) Slide the paper guide (A) to the left, and load the envelopes against the far right of the rear tray WITH THE PRINT SIDE FACING YOU.

The folded flap of the envelope will be faced up on the left side.

Up to 5 envelopes can be loaded at once.

(4) Slide the paper guide (A) to align it with the envelopes.

Do not slide the paper guide too hard against the envelopes. The envelopes may not be fed properly.

(B) Rear side

Note

Do not load sheets of paper higher than the load limit mark.

Note

The machine may make operating noise when feeding paper.

After loading envelopes

Select the size and type of the loaded envelopes on the print settings screen of the printer driver.